ASSEMBLY
DANGER:
Laser radiation. Avoid direct eye contact with light source.
ALIGNING THE LASER GUIDE LINE
See Figure 14.
The laser guide will generate a laser line on the work surface when the saw blade is spinning. The laser line will appear as a broken line on the workpiece when the blade assembly is in the uppermost position and the motor switch is activated. This broken line will let you see your mark and your laser guide line at the same time, and will assist you in lining up your mark for more accurate cutting of the workpiece.
Align the laser line and your mark with the blade at the uppermost position. Once both lines are in alignment, do not move the workpiece until after you have finished cutting.
As the blade assembly is lowered toward the workpiece, the broken line will become solid.
Follow the directions below for using the laser guide:
Removing the Mark:
Position the laser line on the left edge of your mark on the work surface in order to remove the mark.
To Cut the Mark:
Position the laser line near or over your mark on the work surface in order to cut the mark.
To Leave the Mark:
Position the laser line near the right edge of your mark on the work surface in order to leave the mark.
After you have become familiar with using the laser guide, you will be able to remove, cut, or leave your mark on the work surface. Practice will teach you the correct position for aligning the laser line with your mark. To adjust the position of the laser line, see the Adjustments section of this manual.
BROKEN |
LINE |
Fig. 14
19
