ROOM TEMPERATURE DISPLAY
Temperature is indicated by the L.E.D. display on the control panel. The room temperature is indicated by the flashing L.E.D., and the set temperature by the steady L.E.D. When the set temperature is reached, the flashing L.E.D. disappears and the temperature is indicated by the steady L.E.D. You will notice the fan speed changing as the heater modulates to match the room temperature.
TO TURN UNIT OFF
TEMPERATURE LEVEL
LO 60 64 68 72 76 80 HI
Temperature 
Control
IGNITION BUTTON
Depress ignition ON/OFF button again. The switch will return to the off position.
Do not turn off unplugging at the power outlet. Convection fan continues to run until heater is cool. The convection fan may start again after a few minutes to remove any residual heat.
Filter
ON
ON/OFF
ECONOMY BUTTON
ECONOMY
To select ‘Economy Mode’, push the ‘Economy’ button, the green lamp will glow. 30 minutes after the room temperature reaches the preset temperature (set by the thermostat), the ‘Economy Mode’, if set, reduces the
Economy
temperature by 2°F, after another 30 minutes it reduces the temperature by a further 2°F, this is an energy saving feature. When the heater is running in lowest position on the thermostat, the ‘Economy Mode’ does not operate. It does not operate if the heater is under capacity for the room size.
FILTER LAMP
If the filter lamp glows during operation, check air filter for dust. If there is dust present, clean filter. See section on care of heater. Turn heater off before cleaning filters.
Filter
ON
ON/OFF
OPERATING PRECAUTIONS
Please read this section carefully, before using your Forced flue heater.
Gas Type, Power Source, and Manufactured Date
■Type of gas, power source and manufactured date are displayed on the nameplate placed on the right side of the unit.
• Do not use gas other than the type of gas (gas group) indicated on the nameplate.
– 26 –
