Rinnai RHFE-431FA Fitting Unit, AIR Inlet Hose, Locking Clamp Screw Clamp and Insulation

FITTING UNIT

AIR INLET HOSE

Manifold

Inlet hose

Hose clip

Detail of Hose clip

Plastic tie

Inlet elbow

Inlet hose

When servicing unit replace plastic tie with new one. (Available at local hardware store or contact local distributor.)

2.Fit the locking clamp over connection between sliding tube and manifold. Engage the hook and rotate it until it snaps against the body of the clamp.

Manifold

Flue outlet

Sliding tube

Hook

Locking	Locking
clamp	Clamp

3.Fit the screw clamp between the sliding tube and the flue elbow. Secure with the 4mm screws supplied. The flue outlet is now locked into position.

Flue Outlet tube screw	Locking clamp
screw clamp

LOCKING CLAMP SCREW CLAMP AND INSULATION.

The following components can be fitted by reaching down the rear of the appliance as it is positioned against the wall.

Flue elbow

Flue Outlet sliding tube

Manifold

1.Connect the flue outlet to the manifold by extending the stainless steel sliding tube until it is fully inserted into the manifold.

Manifold

Sliding Tube

Slide

Do not extend flue tube beyond red line.

4.Slide the insulation sleeve up to the flue manifold, slip the securing clip over the sleeve as shown.

Fit clip

Slide insulation sock

Flue elbow	Flue outlet
	Sliding tube
Sock	Slide to here

– 22 –