VENT LOCATION
FITTING TOP SPACER + WALL CLIP
FLUE MANIFOLD POSITION
Center of hole for flue manifold can be drilled anywhere within the shaded area. (To avoid studs, etc.)
FOR WEATHERBOARD WALLS DRILL THROUGH CENTER OF WEATHER BOARD FROM OUTSIDE, THEN DRILL FROM INSIDE THROUGH PLASTER- BOARD.
11" Cavity Opening (280mm)
Tighten all screws.
Top spacer
Spacer bracket
8 7/16" |
| (214mm) |
|
| ||
|
|
| ||||
|
|
|
|
|
| |
|
|
|
|
|
|
|
Flue Hole |
|
| ||||
|
|
| 3 1/8" | (80mm) | ||
|
|
| ||||
|
|
| ||||
|
|
| ||||
|
|
| ||||
|
|
|
|
|
|
|
R11"
(R279mm) | .0" | ||
| (R206mm) | ||
|
| R8 | |
|
|
|
|
|
|
|
|
89/16"
(217mm)
SECURE HEATER TO WALL
Top spacer
Spacer bracket
Wall bracket
Before drilling the flue hole, check for water and gas pipes as well as electric cables. Use a 3 1/8" (80mm) drill for hole through wall.
WALL MOUNTING BRACKETS
Place top back spacer in position. Mark the position of the top edge of the top space on the wall. Move the heater away from the wall. Mark center lines 1 1/8" (30mm) down from the top edge mark, and 1 9/16" (40mm) From the left and right hand sides of the top spacer. Attach wall brackets at the marked position.
Replace top spacer, clipping the spacer into the wall brackets at the same time as attaching it to the heater. Secure top spacer with the screws provided.
THE HEATER IS NOW SECURED TO THE WALL.
Spacer
Replace fan filter.
– 15 –