Rinnai RHFE-431WTA Your Weekly Timer Program, Factory PRE-SET Program, Write your own program

YOUR WEEKLY TIMER PROGRAM

■Points to consider before writing your program:

When do I want the heater to operate, and what temperature do I want?

When do I not want the heater to operate?

Will I use the same settings for everyday day of the week, or do I need a separate program for the weekdays, and the weekend? Do I need a separate setting for each day of the week?

■Points to remember when writing your program:

The four periods are set within a 24 hour time span.

The start of a new period marks the end of the previous one, so each period only requires a START time.

Period 4 ends with the start of period 1 on the next day(see page 26 for a reminder).

Each period must be set to a later time than the one before it.

If you want to heat during the period, select a temperature: H(high), 80 → 60, L(low).

If you do not want to heat during this period, select the OFF setting.

■Write your own program:

Use the tables below to write your own weekly timer program, then turn to page 28 to program the timers.

Start Time Temperature or OFF

1

2

3

4

Start Time Temperature or OFF

1

2

3

4

FACTORY PRE-SET PROGRAM

The heater comes shipped with a factory set program(opposite).

If the heater is not set with a new program it will run according to this program when you operate the timers(“Auto” mode-see page 32).

If the Weekly Timer program settings are erased (see page 24), the heater will revert to this program.

WEEK DAY

		Start Time	Temp or OFF
1		6:00 am	72°F
2		8:30 am	60°F
3		5:00 pm	74°F
4		11:30 pm	60°F
	WEEK END
		Start Time	Temp or OFF
1		7:00 am	72°F
2		12:00 pm	70°F
3		5:00 pm	74°F
4		11:30 pm	60°F

– 31 –