Rinnai RHFE-431WTA Operating The Heater Manually, To turn the heater ON, To turn the heater OFF

OPERATING THE HEATER MANUALLY

■To turn the heater ON:

1Press the “ON/OFF” button.

Check to see if the “Man” or “Auto”

2indicator is displayed:

If the “Auto” indicator is displayed then press the “Auto” button. The indicator will change to “Man”.

Go to Step 3.

ON/OFF

		indicator
Set	Room	ON	Frost	Eco
pm	Auto
Tu
1			Override	Auto	ON/OFF
		indicator

If the “Man” indicator is displayed go to Step 3.

3	Select the desired room temperature
	by pressing the “▲” or “▼” buttons.

Set	Room
pm	ON
	Man
Tu

Set	Room
pm	ON
	Man
Tu

Programming

Clock Select Timers

The heater will start and run for 90 seconds so that it can check the room temperature (the indicator will show).

If the room temperature is lower than the pre-set or desired temperature the heater will continue to run.

If the room temperature is higher than the pre-set or desired temperature, the heater will go into “stand- by” mode, and will start when the room temperature falls below the pre-set temperature.

If the heater does not ignite on initial use, this may be due to air remaining in the gas supply line. The spark generator will only continue for 15 seconds. After this it will be necessary to press the ON/OFF button OFF, then ON again.

■To turn the heater OFF:

1 Press the “ON/OFF” button.

Frost	Eco
pm
Tu
Override	Auto	ON/OFF

DO NOT turn heater off by unplugging the power cord.

The convection fan will continue to run until the appliance cools.

– 25 –