Roberts Gorden TF-300 Maintenance Checklist, Installation Code and Annual Inspections, Reflector

SECTION 12: OPERATION AND MAINTENANCE

12.5 Maintenance Checklist

Installation Code and Annual Inspections:

All installation and service of ROBERTS GORDON® equipment must be performed by a contractor qualified in the installation and service of equipment sold and supplied by Roberts-Gordon LLC and conform to all requirements set forth in the ROBERTS GORDON® manuals and all applicable governmental authorities pertaining to the installation, service and operation and labeling of the

equipment.

To help facilitate optimum performance and safety, Roberts-Gordon LLC recommends that a qualified contractor conduct, at a minimum, annual inspections of your ROBERTS GORDON® equipment and perform service where necessary, using only replacement parts sold and supplied by Roberts- Gordon LLC.

The Vicinity of the Heater Do not store or use flammable objects, liquids or vapors near the heater. Immediately remove these items if they are present.

See Page 5, Section 3.

Vehicles and Other Objects

Maintain the clearances to combustibles.

Do not hang anything from, or place anything on, the heater.

Make sure nothing is lodged underneath the reflector, in between the tubes or in the decorative or protective grilles (included with select models).

Immediately remove objects in violation of the clearances to combustibles.

See Page 5, Section 3.

Reflector	Support reflector with reflector hanger and support strap.
	Reflector must not touch tube.
	Make sure there is no dirt, sagging, cracking or distortion.
	Do not operate if there is sagging, cracking or distortion.
	Make sure reflectors are correctly overlapped. See Page 26, Section 7.6.1.
	Clean outside surface with a damp cloth.
Vent Pipe	Venting must be intact. Using a flashlight, look for obstructions, cracks on the
	pipe, gaps in the sealed areas or corrosion.
	The area must be free of dirt and dust.
	Remove any carbon deposits or scale using a wire brush.
	See Page 37, Section 9.
Outside Air Inlet	Inlet must be intact. Look for obstructions, cracks on the pipe, gaps in the
	sealed areas or corrosion.
	The area must be free of dirt and dust. Clean and reinstall as required.
Tubes	Make sure there are no cracks.
	Make sure tubes are connected and suspended securely.
	See Page 16, Section 7.
	Make sure there is no sagging, bending or distortion.
	Clean or replace as required.

51