34
Chapter 1 Making a performance/Creating a patch
Patch Edit Parameters
These parameters allow you to select the sounds that will be triggered by pads on or connected to the SPD-S (or foot switch).
WAVE A
Select a wave to be assigned to a pad (Press EDIT). Two waves, A and B, can be assigned to any pad. Only Wave A can be
assigned to the foot switch. This is for configuring wave A.
Hit the pad or press the PAGE buttons while holding down [SHIFT] to choose what you are editing. Pad indicators light up to
indicate what pad/trigger you are working on.
Setting up: Press PAGE buttons to change the parameter and press [-]/[+] to change the value.
If you change the value in Level or Pan during sound production, the sound is stopped.
WAVE B
Select a wave to be assigned to a pad (Press EDIT). This is for configuring wave B.
Hit the pad or press the PAGE buttons while holding down [SHIFT] to choose what you are editing. Pad indicators light up to
indicate what pad/trigger you are working on.
Wave B can NOT be assigned to any foot switch.
Setting up: Press PAGE buttons to change the parameter and press [-]/[+] to change the value.
Parameter Value Descriptions
A
(Wave)
I
000 (OFF),
I
001–399,
C
001–500
Specify the wave number (sound) assigned to the wave A position.
I
000 (OFF): Selected when you want no sound to be produced
I
001–399: Internal memory
C
001–500: Memory card
* By pressing [CARD], you can select the top number of the internal memory or of the
memory card.
A Level 0–127 Set the volume of wave A.
A Pan L15–CENTER–R15,
RANDOM
Set the pan position (left-right balance) of wave A. If set to RANDOM, the pan position
varies each time the sound is reproduced.
Parameter Value Descriptions
Wave SW
(Wave Switch)
OFF,
VELO,
FOOTSW
Determines HOW waves A and B will sound.
OFF: Wave B is not triggered.
VELO: The sound to be reproduced, either wave A or B, is determined by the velocity (strike
force). The threshold level is specified with VeloSWPoint, below.
FOOTSW: You can use a foot switch to change between wave A and wave B. When you press
the switch, wave B is triggered. Otherwise, wave A is reproduced. (FOOT SW in
CONTROL SW in SETUP must be set to WAVE SW. -> p. 79)
If you hold down [SHIFT] and press [FUNC], the parameter is reset to its initial value.
If you hold down [SHIFT] and press [ENTER], the parameter is copied to all other pads/triggers.
SPDS_e.book 34ページ ２００４年４月１９日 月曜日 午前９時５８分