73
Chapter 6 Using a CompactFlash Memory Card
Chapter 6
BACKUP SAVE Here's how to save backup data (SPD-S settings: patch, wave, setup) to a memory card. A maximum of four backup data sets can
be saved on a card.
If there is not enough free memory on a card, it will only be able to store a limited number of backup data sets.
1.
Set the following parameter.
Press [-]/[+] to change the value.
2.
Press [>] to display “sure?” Give a name to the backup data.
The initial value is Backup*. The final character (*) is the number specified in Step 1.
Press the PAGE buttons to move the cursor under the name and press [-]/[+] to change the character at the cursor position.
When the name is complete, press [ENTER] to save it.
While saving is in progress, “now processing..” is displayed. Afterwards, the SPD-S returns to the original mode.
Do not power the unit off during execution.
BACKUP DELETE This procedure allows you to delete backup data (SPD-S settings: patch, wave, setup) on a memory card.
1.
Set the following parameter.
Press [-]/[+] to change the value.
2.
Press [>] to display “delete, sure?” Press [ENTER] to delete the backup data set.
While deleting is in progress, “now processing..” is displayed. Afterwards, the SPD-S returns to the original mode.
Do not power the unit off during execution.
Parameter Value Descriptions
Save 1–4 Select the destination number to which the backup data is to be saved.
* By pressing [SHIFT] and [FUNC], you can select a new (empty) destination number.
Parameter Value Descriptions
Delete 1–4 Specify the backup data set to be deleted.
SPDS_e.book 73ページ ２００４年４月１９日 月曜日 午前９時５８分