95
Effect List
Appendices
2: DLYEDREVERB (Delayed Reverb)
Adds a delay before reverb to delay the reverb sound.
fig.DelayedReverb.eps
In addition, if you press the PAGE buttons, “Knob,” “Velo” and “Pedal” are displayed. You can then select the parameters to be
controlled with the EFFECTS CONTROL knob, the strength (velocity) used in hitting a playing surface, and the expression pedal.
Parameter Value Descriptions
EQ Low -12.0–+12.0 dB Low frequency amplification/attenuation
EQ High -12.0–+12.0 dB High frequency amplification/attenuation
DlyTime 1.5–2000 ms Delay time from the start of the original sound to the start of the delay sound
DlyFeedBak -98–+98 % Rate at which the delay sound is fed back (Negative: reversed phase)
LowCut THRU,
50–4000 Hz
Frequency below which the delay sound fed back to the reverb is cut off (THRU: the low
cut filter disabled)
RevType HALL,
ROOM,
PLATE
HALL: reverb simulating a concert hall
ROOM: reverb simulating a room
PLATE: reverb simulating a metal-plate reverb unit
RevTime 0.1–10.0 s Duration of the reverb
LF Damp THRU,
50–4000 Hz
Cutoff frequency for low frequency damping (THRU: no damping)
HF Damp 1000 Hz–12.5 kHz,
THRU
Cutoff frequency for high frequency damping (THRU: no damping)
ReverbLevel 0–127 Volume level of the reverb
Value Parameters controlled with Knob and Pedal
(See the table above for details.)
Descriptions
OFF — —
DELAYTIME DlyTime —
DLYFEEDBAK DlyFeedBak —
REVTIME RevTime —
REVERBLEV ReverbLevel —
WIDE RevTime, HF Damp, ReverbLevel The overall reverb effect is controlled.
Value Parameters controlled with Velo
(See the table above for details.)
Descriptions
OFF — —
DLYFEEDBAK DlyFeedBak —
REVTIME RevTime —
REVERBLEV ReverbLevel —
RVTIME+LEV RevTime, ReverbLevel The reverb gets deeper as strike force increases.
RESOTUNE DlyTime, DlyFeedBak Produces a special reverb sound, the pitch of which varies
depending on the strike force.
L out
Feedback
L in
ReverbLevel
Delay
2-Band
EQ
R out
R in 2-Band
EQ
Reverb
Low Cut
Filter
SPDS_e.book 95ページ ２００４年４月１９日　月曜日　午前９時５８分