48
Chapter 2 Wave Editing
Marking Function
You can set the start and end points by the timing of your
button operation while a wave is being played back. Take the
following steps on the wave mode screen, the Start screen or
the End screen (p. 47).
Changing both the start and the end
points
1.
Press [START/STOP] to play back a wave.
2.
At the point that you want to designate as the
start point, hold down [SHIFT] and press
[WAVE].
[MARK] starts flashing and the Start screen is displayed.
3.
At the point that you want to designate as the
end point, hold down [SHIFT] and press
[WAVE].
[MARK] lights steadily and the End screen is displayed.
The setting procedure is complete.
*If you fail to achieve the settings you want, hold down [SHIFT]
and press [WAVE] for a moment. After [MARK] is
extinguished, follow steps 1 to 3 again.
4.
Press [WAVE] to return to the wave mode.
A “now writing …” indication appears and the settings
are saved.
Changing the start point alone
1.
Press [START/STOP] to play back a wave.
2.
At the point that you want to designate as the
start point, hold down [SHIFT] and press
[WAVE].
[MARK] starts flashing and the Start screen is displayed.
3.
Press [START/STOP] to stop playing back the
wave.
[MARK] lights steadily. The setting procedure is
complete.
*If you fail to achieve the settings you want, hold down [SHIFT]
and press [WAVE] for a moment. After [MARK] is
extinguished, follow steps 1 to 3 again.
4.
Press [WAVE] to return to the wave mode.
A “now writing …” indication appears and the setting is
saved.
Changing the end point alone
1.
Before triggering a sound, hold down [SHIFT]
and press [WAVE].
[MARK] starts flashing and the Start screen is displayed.
2.
Press [START/STOP] to play back the wave.
3.
At the point that you want to designate as the
end point, hold down [SHIFT] and press
[WAVE].
[MARK] lights steadily and the End screen is displayed.
The setting procedure is complete.
*If you fail to achieve the settings you want, hold down [SHIFT]
and press [WAVE] for a moment. After [MARK] is
extinguished, follow steps 1 to 3 again.
4.
Press [WAVE] to return to the wave mode.
A “now writing …” indication appears and the setting is
saved.
Canceling a mark
1.
Hold down [SHIFT] and press [WAVE] for a
moment so [MARK] is extinguished.
The Start screen appears.
The start point is reset to the top of the wave and the end
point to the end of it.
2.
Press [WAVE] to return to the wave mode.
A “now writing …” indication appears and the setting is
saved.
SPDS_e.book 48ページ ２００４年４月１９日 月曜日 午前９時５８分