Roland Ver. 4.5 user manual System Requirements Macintosh

System Requirements Macintosh

The following table lists the minimum and high volume recommended system setup to run RIP Software. System requirements vary according to the size of the files to be printed, the output device used, and other variables. Your particular setup and intended use of the software determine what hardware and software setup you need to get the most out of RIP Software. If you are working with relatively small files, the minimum setup may be sufficient. Similarly, if you are working with large files, you should consider the recommended setup. Consult your dealer for advice when choosing a system.

	Minimum	Recommended
Processor	Power PC 166	G3 or G4 300 MHz or faster
RAM	128 MB RAM with at least 196 MB of	256 MB RAM with at least 257 MB of
	virtual memory enabled	virtual memory enabled
Install Space	200MB	200MB
Working Disk	2GB or more	4GB or more for storage
Space
Operating System	Mac OS 8.5 – 9x with Appearance	Mac OS 8.5 – 9.x with Appearance
	Manager and ColorSync installed	Manager and ColorSync installed
Video	800 x 600 screen resolution with 16 bit	1024 x 768 screen resolution with 16 bit
	colors	colors
Others	4x CD-ROM Drive	16x CD-ROM Drive
Parallel Output	MAC/PCI Card	MAC/PCI Card
USB Output	USB-PIA (requires Mac OS 8.5 or later)	USB-PIA (requires Mac OS 8.5 or later)
Network Output (*)	10 BASE-T	100 BASE-TX

(*)Only when printers with network capabilities are used. TCP/IP should be installed and working properly.

6