NOTE
Theslotinthesideofthe5110-1-1(PortingPlate)mustlineupwiththeslot inthe5110-7-1(GunHandle).
9.Set the 5105-6-1 (Toggle Washer) into the washer seal seat of the 5110-1-1 (Porting Plate) large side down.
10.Set the 5110-6-1 (Cylinder Gasket) over the screws, matching the slots in the 5110-1-1 (Porting Plate)
11.Carefully position the 5106-00-01 (Gun Actuator Assembly) over the 5110-7-1 (Gun Handle Assembly) and fasten with the two 5105-12-1 (Front Screws) and the 5105-13-1 (Rear Screws).
12.If necessary, adjust the 5105-8-1 (Trigger Lock) by pulling the
5105-16-1 (Trigger) to “full out”, then flip the Trigger Lock up until it hits the smallest part of the 5110-8-1 (Trigger Lock Screw). Loosen the 7102-6-4 (Socket Cup Point Set Screw) and adjust the Trigger Lock Screw until it clears with minor interference. The locking legs on the Trigger Lock Screw must be vertical. The Trigger Lock should lock the trigger in both the open and closed position. Once adjusted, tighten the 7102-6-4 (Socket Cup Point Set Screw).
13.With the two 7102-8-8 (Slotted Pan Head Screws), mount the 5105-2-1 (Trigger Guard).
6 | SUPER PRO GUN & |
| SUPER PRO GUN II |
