NOTE

BeforeinsertingtheSealAlignmentTool,aligntheholesinthe5401-6-1 (TeflonCatalystSeal)withtheholesinthe5104-1-1(GunBlock)asclosely aspossible.

7.Press firmly, or tap with a hammer until the seal assembly bottoms out in the 5104-1-1 (Gun Block), then gently remove the Seal Installation Tool.

8.Hold the 9301-4-1 (Catalyst Seal Alignment Tool) firmly with a pair of pliers.

9.Insert the tapered end of the 9301-4-1 (Catalyst Seal Alignment Tool), into the 5104-1-1 (Gun Block) through the catalyst fitting port on the back of the Gun Block.

10.Gently press and move the Seal Alignment Tool around until the holes in the 5104-6-1 (Teflon Catalyst Seal) align with the catalyst port in the 5104-1-1 (Gun Block) See Fig. 3.3.

Fig. 3.3

11.Install and hand tighten the 5104-8-1 (Packing Nut).

12.Install the resin seal components into the 9301-5-1 (Seal Installation Tool) in the following order: 5104-7-1 (Packing Ring), 5104-5-1 (Teflon Resin Seal), and the 5104-4-1 (Relief Spacer). See Fig. 3.4.

13.Insert the Seal Installation Tool into the resin port of the 5104-1-1 (Gun Block) See Fig. 3.4.

NOTE

BeforeinsertingtheSealAlignmentTool,aligntheholesinthe5401-5-1 (TeflonResinSeal)withtheholesinthe5401-1-1(GunBlock)asclosely aspossible.

SUPER PRO GUN &

9

SUPER PRO GUN II

 

Page 14
Image 14
Roper M6707-1-1 manual Super PRO GUN