NOTE
Onceinplacethespringofthe7304-4-1(LipSeal)shouldbefacingout.
3.Screw the 5105-10-1 (Trigger Nut) into the 5110-7-1 (Gun Handle) and tighten. Coat the 5110-4-1 (trigger stem) with 6706-3-1 (Pro Gun Oil) and install from the inside cavity of the 5110-7-1 (Gun Handle) through the 5105-10-1 (trigger nut).
4.Place the 5105-15-01 (Pivot Plate) into the slot in the
5110-7-1 (Gun Handle Assembly), and push the 7203-4-10 (Slotted Spring Pin) located on the backside of the 5105-16-1 (Trigger) into the hole in the 5110-4-1 (Trigger Stem). Line up the 5105-15-2 (Pivot Plate Bushing) to the lower pivot hole in the Gun Handle, insert the 7102-10-12 (Slotted Flat Head Screw) and tighten.
NOTE
WheninstallingtheTriggerAssemblythe5105-8-1(TriggerLock)mustbein the“down”position. Youmayfinditeasiertoassemblethegunhandleby placingtheflatsatthebackofthe5110-7-1(GunHandle)inavise. Thiswill supporttherearscrews(5105-13-1)frompushingdownduringassembly.
5.Set the 9203-2-1 (Compression Spring) into the spring seat located in the upper cavity of the 5110-7-1 (Gun Handle).
NOTE
For2-stagechopperonly.
Set the 5110-3-1 (two position gun detent plate) over the 9203-2-1 (Compression Spring). The elevated shoulder of the 5110-3-1 (two position detent plate) faces up.
6.Place the small pinhole in the 5110-2-1 (Slide Valve) over the pin through the 5110-4-1 (Trigger Stem), and push down compressing the spring into the handle cavity.
7.Place the 5110-5-1 (Gun Handle Gasket) over the screws, matching the slot to the slot in the 5110-7-1 (Gun Handle).
8.Lightly lubricate the topside of the 5110-1-1 (Porting Plate) with 6706-3-1 (Pro Gun Oil) and push it over the 5110-2-1 (Slide Valve) keeping the Slide Valve connected to the 7203-4-9 (Slotted Spring Pin) in the 5110-4-1 (Trigger Stem).
