Caring For Your Range
Bum And Electrical Shock Hazard
Make sure all controls are OFF and the range is cool before cleaning. Failure to do so can result in burns or electrical shock.
The control knobs
1.Turn control knobs to the OFF position.
2.PulI control knobs straight off.
3.Wash in warm, soapy water.
4.Rinse well and dry completely. Do not soak.
The control panel
1.Wipe with warm, soapy water or spray glass cleaner, and a soft cloth.
2.Rinse well.
3.Dry with soft cloth.
4.Replace control knobs by pushing them firmly into place.
NOTE: When cleaning, never use steel wool, abrasives, or commercial oven cleaners which may damage finish. After cleaning, make sure all control knobs point to the OFF position.
The surface units and reflector bowls
Removing
3.Pull the surface unit straight away from the receptacle.
4.Lift out the reflector bowl. See Cleaning Chart on page 12 for cleaning instructions.
Replacing
1, Make sure alI surface units are turned OFF.
2.Line up openings in the reflector bowl with the surface unit receptacle.
3.Hold the surface unit as level as possible with the terminal just started into the receptacle. Push the surface unit terminal into the receptacle.
4.When the terminal is pushed into the receptacle as far as it will go, the surface unit wilI fit into the reflector bowl.
Reflector bowls reflect heat back to the utensils on the surface units. They also help catch spills. When they are kept clean, they reflect heat better and look new longer.
If a reflector bowl gets discolored, some of the utensils may not be flat enough, or some may be too large for the surface unit. In either case, some of the heat that’s meant to go into or around a utensil goes down and heats the reflector bowl. This extra heat can discolor it.
1.Turn off alI surface units and let cool.
2.Lift the edge of the unit opposite the receptacle, just enough to clear the reflector bowl.
Fire And Electrical Shock Hazard
1 ;;;;,“,he | reflectqr bowls | 1 |
with foil. Fire or electrical shock |
| |
Page 9
