Rosewill RXS-3323 Appendix B Troubleshooting & FAQ, Features, Install the Device, Question

Internet Camera RXS-3323/RXS-4324User Manual

Appendix B: Troubleshooting & FAQ

Question		Answer
	Features
The video and audio	The device utilizes H.264, MPEG4 and JPEG triple compression to providing high
codec is adopted in the	quality images. Where H.264 and MPEG4 are standards for video compression and
device.	JPEG is a standard for image compression. The audio codec is defined as AMR for
	3GPP and G.711/G.726 for RTSP streaming.
The maximum number of	The maximum number of users is limited to 20. However, it also depends on the total
users can access the	bandwidth accessed to this device from clients. The maximum data throughput of the
device simultaneously.	device is around 20~25Mbps for UDP mode and 10Mbps for HTTP mode. Therefore,
	the actual number of connected clients is varying by streaming mode, settings of
	resolution, codec type, frame rate and bandwidth. Obviously, the performance of the
	each connected client will slow down when many users are logged on.
The device can be used	The device is not weatherproof. It needs to be equipped with a weatherproof case for
outdoors or not.	outdoors using. However, equipped with a weatherproof case might disable the audio
	function of the device.
	Install the Device
Status LED does not light	• Check and confirm that the DC power adaptor, included in packaged, is used. Secure
up.	the power connector and re-power it on again.
	• If also check if IPWizard II can find out the camera over the network after plug in the
	power and network cable. This may due to the LED light has been set to turn off.
	• If the problem is not solved, the device might be faulty. Contact your dealer for
	further help.
The network cabling is	The device uses Category 5 UTP cable allowing 10 and/or 100 Base-T networking.
required for the device.
The device will be	If a firewall exists on the network, port 80 is open for ordinary data communication.
installed and work if a	The HTTP port and RTSP port need to be opened on the firewall or NAT router.
firewall exists on the
network.
The username and	Username = admin and leave password blank.
password for the first time	Note: that it’s all case sensitivity.
or after factory default
reset
Forgot the username and	Follow the steps below to restore the factory default.
password	1. Restore the factory default setting by press pressing and holding down more than 3
	seconds on the device.
	2. Reconfigure the device.
Forgot the IP address of	Check IP address of device by using the IPWizard II program or by UPnP discovery.

60