RuggedCom RX1510 manual RuggedBackbone Modules, LM1 through LM4

2. RuggedBackbone™ Modules

2. RuggedBackbone™ Modules

The RX1510 chassis provides six module slots . Each slot accommodates a particular type of RuggedCom module. Figure 2.1, “RX1510 Chassis Slot Assignment”shows the module slots on the RX1510.

Figure 2.1. RX1510 Chassis Slot Assignment

The RX1510 chassis supports the following modules:

LM1 through LM4

The RX1510 chassis supports up to four line module (LM) cards. For more information on line modules, see Section 2.2, “Line Modules (LM)”.

All modules are built to the RuggedRated™ specifications of the RuggedBackbone™ RX1510. Each module type is described in the following sections.

To install a module into the RuggedBackbone™ chassis, align the module guide ribs with the channels on the chassis. Push the module in as far as it will go, being sure to push through the resistance provided by the grounding springs. When properly seated, the module flange will rest on the main chassis frame. Tighten the thumbscrews using finger strength only.

RuggedCom® RuggedBackbone™ 11 RX1510 Installation Guide Rev 104