Runco CW-50MC manual Data Format

RS-232C ADJUSTMENT MODE

Interface

1)Connector: D-sub 9 pins (male)

2) Pin Layout:

Pin No.	Signal
1	NC (not connected)	1	5
2	TxD (Transmit Data)
3	RxD (Receive Data)
4	NC (not connected)
5	GnD
6	NC (not connected)	6	9
7	NC (not connected)
8	RTS (Request to Send)
9	NC (not connected)

3)Baud Rate: 9600 bps (standard)

(switchable to 1200, 2400, 4800, 19200, 38400 bps)

NOTE: The baud rate of this display should be set to match the baud rate of the computer. Also, when the RS-232C cable is to be extended over a long distance, a slower baud rate is recommended.

4)Data Format

Start: 1-bit

Data: 8-bit

Parity: 0 (no parity)

Stop: 1-bit

5) Connection	Control PC	Plasma Display	Control PC	Plasma Display
	(with D25 serial port )	(CW-43/50MC)	(with D9 serial port)	(CW-43/50MC)
	RXD 3	2 TXD	RXD 2	2 TXD
	TXD 2	3 RXD	TXD 3	3 RXD
	CTS 5	8 RTS	CTS 8	8 RTS
	GND 7	5 GND	GND 5	5 GND

Straight Cable

* D-sub 9-pin/D-sub 25-pin conversion tables are now available on the. market

NOTE: Computer manufacturers may not use the same pin assignments. In case of communication difficulties, check pin functions not just pin numbers.

20