Runco Vision 85 manual Installing and Adjusting the CineWide Anamorphic Lens

Installation

3.9

Installing and Adjusting the CineWide Anamorphic Lens

If you are installing a CineWide-equipped projector, proceed as follows to install and adjust the anamorphic lens.

It is extremely important that the primary lens is properly adjusted

Note before you install the anamorphic lens. Ensure that the image from

the primary lens is perfectly centered on the screen.

The standard Vision 85/CineWide uses a prismatic-style anamorphic lens. This type of lens compresses the height of the image (as opposed to stretching the width) to achieve a 2.35:1 aspect ratio with a 1.78:1 display device.

The standard Vision 85 Anamorphic lens mount kit consists of everything shown in Figure

3-16.Some components shipped with your projector may differ slightly from what is shown in these instructions.

If any items are missing or damaged, please contact your Vidikron dealer or Vidikron Customer Service at (888) 4VIDIKRON.

1Anamorphic Lens

		6	Pitch/Y-Adjustment
			Screw, Phillips
			Pan Head, 4-40 x 3/8” (2x)
			and Fender Washer (2x)
2	Base Plate
3	Screw, Phillips	5	Vertical Mounting
			Bracket (2x)
	M6x16mm (4x) and
	1/4” Flat Washer (4x)	4	Yaw/Z-Adjustment

(not shown; secures Base Plate	Lever (2x) and
to bottom of projector)
	Fiber Washer (2x)

Figure 3-16. Vision 85 Anamorphic Lens Mounting Assembly - Exploded View

1.Use the Pitch Adjustment Screws (item #3) and Washers (item #6) to attach the Mounting Brackets (item #2) to the Anamorphic Lens (item #1).

2.Use the four Y-Adjustment Screws (item #5) and Washers (item #4) to attach the Anamorphic Lens assembly and Spacers (item #7) to the front of the projector. (Do not fully tighten the screws yet.)

32 Vidikron Vision 85 Owner’s Operating Manual