ASSEMBLY
ASSEMBLING STORAGE BRACKETS
See Figure 9.
■Take storage brackets from loose parts.
■Take the following hardware from the leg stand hardware bag:
4 screws
4 hex nuts
4 washers (1/4 in.)
■Secure storage brackets to upper braces of leg stand as shown in figures 8 and 9.
MOUNTING THE LEG STAND ON THE TABLE SAW BASE
See Figure 10.
■Take the following from a small hardware bag:
4 hex bolts
4 hex nuts
8 flat washers (1/4 in.)
Note: This hardware was in the bag with hardware for assembling the leg stand and leveling feet.
WARNING:
Do not lift the saw without help. The saw base weighs approximately 75 lbs. Hold it close to your body. Keep your knees bent and lift with your legs, not your back. Ignoring these precautions can result in back injury.
■Place the leg stand on the table saw base. Align the holes in the table with the holes in the end braces.
■Place a flat washer on a bolt and insert through hole. Add a flat washer and a hex nut. Hand tighten. See Figure 10.
■Repeat for three remaining holes. Tighten all hardware with a wrench. You may find it helpful to use one wrench to hold the head of the bolt and one to tighten the hex nut.
STORAGE BRACKET(S) | UPPER BRACE |
LOWER BRACE
LEG
LEG STAND ASSEMBLED
Fig. 9
WARNING:
Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and possible serious injury.
TO INSTALL FRONT AND BACK RAILS
See Figures 11 and 12.
■Position end plugs on both rails and secure in place by tapping with a block of wood or a rubber mallet.
■Loosen the front rail clamps one half turn from the tightened position. Loosen the square rail holder nut
■Mount the front rail with the scale facing the outside toward the operator.
SAW BASE
FLAT
WASHER
LEG STAND
HEX NUT
HEX BOLT
Fig. 10
Page 16
