MAINTENANCE
WARNING:
0° BOLT
Before performing any adjustment, make sure the tool is unplugged from the power supply and the switch is in the OFF position. Failure to head this warning could result in serious personal injury.
TO SET BLADE AT 0° OR 45°
See Figure 45.
The angle settings of your saw have been set at the factory |
|
and, unless damaged in shipping, should not require setting |
|
during assembly. After extensive use, it may need to be |
|
checked. | 45° BOLT |
■Push the bevel locking lever to the right. Turn the blade adjusting handle to angle the blade. Use a combination square to check squareness between the blade and saw table.
■If the blade is not perfectly vertical (0°), loosen the lock nut on the 0° stop bolt inside the cabinet, position the blade, adjust the stop bolt, then retighten lock nut. See Figure 45, insert. If the bevel indicator is not at zero, adjust it with the two screws above the slot, beside the blade adjusting handle.
■Turn the blade adjusting handle until the bottom of the blade has moved completely to the left side of the slot. Lock the angle by pushing the bevel locking lever to the left.
■If the blade is not an exact 45°, loosen the lock nut on the 45° stop bolt inside the cabinet, position the blade, adjust the stop bolt, then retighten lock nut. See Figure 45, insert.
■Make a test cut.
BEVEL |
| BLADE | |
INDICATOR | BEVEL | ||
ADJUSTING HANDLE | |||
LOCKING LEVER | |||
SCREWS | LOCK NUT | 0° STOP BOLT |
45° STOP BOLT |
|
|
LOCK
Fig. 45
TO CHECK THE ALIGNMENT OF THE RIP FENCE TO THE BLADE
See Figure 46.
WARNING:
Before performing any adjustment, make sure the tool is unplugged from the power supply and the switch is in the OFF position. Failure to head this warning could result in serious personal injury.
■Raise the locking handle to permit the rip fence to be moved.
■Place a framing square beside the blade and move the rip fence up to the square. Take the dimension on the rip scale.
■Move the fence back and turn the framing square 180° to check the other side.
■If the two dimensions are not the same, loosen the two screws on the fence and align it.
CLAMP SCREW
RIP FENCE 
BLADE
RIP
FENCE
LOCKING | SCREWS |
HANDLE |
|
■ Retighten the two screws. | Fig. 46 |
Page 34
