ASSEMBLY
Assembly is best done in the area where the saw will be used. When you remove the table saw base, loose parts, and hardware from the packing materials, check all items with the loose parts list and drawing. If you are unsure about the description of any part, refer to the drawing. If any parts are missing, delay assembling until you have obtained the missing part(s).
ASSEMBLING LEG STAND
See Figures 8 and 9.
■Take the following hardware from the leg stand hardware bag:
24 carriage bolts
4 leveling feet
32 flat washers (5/16 in.)
32 hex nuts
Note: Remaining hardware from this bag is used for mount- ing leg stand on the table saw base and mounting storage brackets to upper brace.
■Take 4 legs and 8 braces from loose parts.
■Place an upper side brace inside two of the legs, with the legs wide end up. (Upper side braces have two large holes in each end.) Make sure the two posts on the leg align with the small holes on the brace.
UPPER BRACE
■Align the two large holes on the brace and the legs. Insert the carriage bolts. Add flat washers and hex nuts and hand tighten. Repeat for the other upper brace. These are the front and back sets.
■For the side sets, install a upper brace on two legs. Add hardware and finger tighten. Repeat for the other upper brace.
■Use the same steps to install the lower braces. Tighten all hex nuts with a wrench.
■Place a hex nut and flat washer on each leveling foot. Install the leveling feet from the bottom of each leg with the bolts pointing up. Cap with the remaining flat washers and hex nuts but do not tighten.
■Move the leg set to desired location. Adjust the leveling feet with a wrench, then tighten the top hex nut.
BOLT | HEX NUT |
WASHER
CARRIAGE | UPPER | WASHER |
SIDE BRACE |
| |
BOLT |
| HEX |
|
| NUT |
WASHER |
|
|
LEG
HEX NUT
HEX NUT
SCREW
STORAGE | LOWER BRACE | |
BRACKET(S) | ||
|
WASHER
HEX NUT
LEVELING FOOT | Fig. 8 |
Page 15
