ASSEMBLY
■Check to make sure the rail clamps will securely clamp the rail before sliding the entire assembly into position. If not, tighten the square rail holder nut
■Slide the rail into position over both clamps and secure.
■Mount the rear rail, following the same clamping procedure as shown for the front rail. Orient the rear rail as shown in Figure 12.
TO INSTALL MITER TABLE AND FENCE
See Figures13 and 14.
■Install the sliding miter table assembly over the front and rear rails. See Figure 13. Check that it slides easily on the rails. Push both front miter locking clamps down evenly on each side to secure. Repeat for both rear miter locking clamps.
Note: DO NOT force miter locking clamps fully down. Tighten only to flat "seated" position.
■To install the miter fence holder to the miter fence, loosen the attachment bolt by turning the adjusting clamp (the knob on top) counterclockwise. Make sure the adjusting clamp is loose enough so the bolt has enough clearance to slide in the table slot. Slide the tabs into the grooves in the miter fence. See Figure 14.
■Mount the miter fence to the miter table by installing the locator pin (below the miter fence) into hole “A” or “B”. (Hole "A" is closest to the blade.) At the same time, place the attachment bolt in the slot. Secure the adjusting clamp, but do not tighten.
■Adjust the miter indicator to the scale.
■Securely tighten the adjusting clamp.
END PLUG | FRONT RAIL |
REAR RAIL
END PLUG
RAIL
HOLDER NUT
Fig. 12
MITER
TABLE BASE
REAR RAIL
Fig. 13
ADJUSTINGATTACHMENT
CLAMPBOLT
MITER
FENCE HOLDER
MITER FENCE
SCALE
FRONT |
|
|
RAIL CLAMP |
|
|
HANDWHEEL | BLADE |
|
|
| |
BEVEL | ADJUSTING | MITER |
HANDLE | ||
LOCKING LEVER |
| INDICATOR |
LOCATOR
PIN HOLE "A"
Fig. 11 | HOLE "B" |
|
|
| |
| QUICK | TABLE |
| SLOT | |
| STOP | Fig. 14 |
Page 17 |
|
|
