Samsung 3560 manual PCL Menu

Item	Explanation
	Values: Off, On*
	This item determines whether or not the
	printer continues printing when it detects the
Auto	paper unmatched to your paper setting.
	• Off: If the paper mismatch occurs, the
Continue	message will remain on the display and the
	printer will remain off-line until you insert
	the correct paper.

•On: If the paper mismatch occurs, an error message will display. The printer will go offline for 30 seconds and automatically clear the message and continue printing.

	Values: Off*, On
	This item determines how the printer behaves
JAM Recovery	when a paper jam occurs.
	• Off: The printer does not reprint pages.
	Printing performance might be increased
	with this setting.
	• On: The printer automatically reprints
	pages after you clear the paper jam.
	Values: Low*, High
Altitude Adj.
	You can optimize print quality depending on
	the air pressure, such as in a high ground.
	Values: LF*, LF+CR
	This item allows you to append the required
Auto CR	carriage return to each line feed.
	Refer to the following samples:
		AA	AA
		BB	BB
		LF	LF+CR
	Values: 0 ~ 1800 sec		*15 sec
Job Time Out	You can set the time length the printer waits
	before printing the last page of a print job that
	does not end with a command to print the
	page.
	When a job time-out occurs, the printer prints
	the page in the print buffer.

Item	Explanation
	This item allows you to maintain the toner
	cartridge.
	• OPC Cleaning: Cleans the OPC drum of
	the cartridge and produces a cleaning sheet
	with toner debris on it.
Maintenance	• Fuser Cleaning: Cleans the fuser unit
	inside of the printer and produces a cleaning
	sheet with toner debris on it.
	• Life Remaining: This item allows you to
	check how much toner are left in the
	cartridge.

PCL Menu

This menu sets the PCL emulation configuration. You can set the font type, symbol type, lines per page, and point size.

(*: the default setting)

Item	Explanation
	Values: PCL1* ~ PCL68
	You can select the standard font to be used in PCL
	emulation.
Typeface	• PCL1~PCL7’s interval between letters is fixed,
	and PCL8~PCL45’s interval is proportional to
	the font type and point size. You can adjust the
	font size of PCL1~PCL7 using the Pitch item,
	and PCL8~PCL45 can do using Point Size
	item.

•PCL46~PCL54’s interval and point size are fixed.

	Values: ROMAN8 ~ PCCYRILLIC		*PC8
Symbol	This item selects the symbol to be used in PCL
	emulation. The symbol is the group of numbers,
	marks, and special signs being used when
	printing letters.
	Values: 5 ~ 128	*60 (Letter), 64 (A4)
Lines	This item allows you to set vertical spacing from 5
	to 128 lines for the default paper size. The lines
	may differ according to the paper size and
	printing orientation.

3.7

Using the Control Panel