Installing the unit
IMPORTANT : When installing the unit, always remember to connect first the refrigerant tubes, then the electrical lines. Always disassemble the electric lines before the refrigerant tubes.
ffUpon receipt, inspect the product to verify that it has not been damaged during transport. If the product appears damaged, DO NOT INSTALL it and immediately report the damage to the carrier or retailer (if the installer or the authorized technician has collected the material from the retailer).
ffAfter completing the installation, always carry out a functional test and provide the instructions on how to operate the air conditioner to the user.
ffDo not use the air conditioner in environments with hazardous substances or close to equipment that release free flames to avoid the occurrence of fires, explosions or injuries.
ffOur units must be installed in compliance with the spaces indicated in the manual to ensure either accessibility from both sides or ability to perform routine maintenance and repairs. The units’ components must be accessible and that can be disassembled in conditions of complete safety either for people or things. For this reason, where it is not observed as indicated into the manual, the cost necessary to reach and repair the unit (in safety, as required by current regulations in force) with slings, trucks, scaffolding or any other means of elevation won’t be considered
Power supply line, fuse or circuit breaker
ffAlways make sure that the power supply is compliant with current safety standards. Always install the air conditioner in compliance with current local safety standards.
ffAlways verify that a suitable grounding connection is available.
ffVerify that the voltage and frequency of the power supply comply with the specifications and that the installed power is sufficient to ensure the operation of any other domestic appliance connected to the same electric lines.
ffAlways verify that the
ffVerify that the air conditioner is connected to the power supply in accordance with the instructions provided in the wiring diagram included in the manual.
ffAlways verify that electric connections (cable entry, section of leads, protections…) are compliant with the electric specifications and with the instructions provided in the wiring scheme. Always verify that all connections comply with the standards applicable to the installation of air conditioners.
ffBe sure not to perform power cable modification, midway wiring, and multiple wire connection.
• Make sure that you earth the cables.
CAUTION | ||
complete, electric shock or fire may occur. | ||
|
•Install the circuit breaker.
•Make sure that the condensed water dripping from the drain hose runs out properly and safely.
•Install the power cable and communication cable of the indoor and outdoor unit at least 1m away from the electric appliance.
•Install the indoor unit away from lighting apparatus using the ballast.
•Do not install the air conditioner in following places.
PAC MIRAGE |
|
| |
|
| ||
|
| ||
|
|
|
|
|
|
|
|