Samsung HMX-H106SN/XAA Camcorder is intended to be operated from, Instructions, Polarized plug

important safety instructions

17. POWER SOURCES:

The CAMCORDER should be operated only from the

type of power source indicated on the label. If you are

not sure of the type of power supply at your home,

consult your appliance dealer or local power company.

A CAMCORDER is intended to be operated from

battery power, or other sources, refer to the operating

instructions.

18. GROUNDING OR POLARIZATION:

This CAMCORDER may be equipped with either a

polarized 2-wire AC line plug (a plug having one blade

wider than the other) or a 3-wire grounding type plug,

a plug having a third (grounding) pin. If you are unable

to insert the plug fully into the outlet, try reversing the

70-1984, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire and supporting structure, grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding to conductors, location of antenna-discharge unit, connection to grounding electrodes and requirements for the grounding electrode.

ANTENNA

LEAD IN

WIRE

GROUND

CLAMP

plug. If the plug still fails to fit, contact your electrician

to replace your outlet. Do not defeat the safety purpose

of the polarized plug.

19. POWER-CORD PROTECTION:

ELECTRIC

SERVICE EQUIPMENT

ANTENNA DISCHARGE UNIT (NEC SECTION 810-20)

GROUNDING CONDUCTORS (NEC SECTION 810-21)

GROUND CLAMPS

POWER SERVICE GROUNDING ELECTRODE SYSTEM

(NEC ART 250, PART H)

Power-supply cords should be routed so that they are

not likely to be walked on or pinched by items placed

upon or against them, paying particular attention to

cords or plugs, convenient receptacles, and the point

where they exit from the unit.

20. OUTDOOR ANTENNA GROUNDING:

CAMCORDER, be sure the antenna or cable system is

grounded to provide some protection against voltage

surges and built-up static charges, Section 810 of the

National Electrical Code, ANSI/NFPA No.

vi_ English

NEC NATIONAL ELECTRICAL CODE

See figure below.

21.LIGHTNING:

For added protection of this CAMCORDER during a lightning storm or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the CAMCORDER due to lightning and powerline surges.