Samsung HT-D7100/ZF, HT-D7100/EN Connecting the Wireless Subwoofer, Connecting the Front Speakers

Connections

Connecting the Wireless Subwoofer

VOL

PS-WD7100

Connect the power cord on the rear of the subwoofer to the power.

•If the main unit is turned on

The subwoofer will be automatically connected to the product and the Link LED on its front will blink blue for a few seconds.

•If the main unit is turned off

The Link LED on the front of the subwoofer will blink blue for about 30 seconds, then will change to red as the sub switches to STANDBY mode.

Attaching the Toroidal Ferrite Core to the Power Cord of the Subwoofer

If you attach a Toroidal ferrite core to the power cord of the Subwoofer, it will help to prevent RF interference from radio signals.

1.Pull the fixing tab of the Toroidal ferrite core to open it.

2.Make three loops in the power cable of the subwoofer.

3.Attach the Toroidal ferrite core to the Subwoofer power cord as the figure shows and press it until it clicks.

RL

ID SET

Connecting the Front Speakers

1.Press down the terminal tab on the rear of the speaker.

2.Insert the black wire into the black terminal (–) and the red wire into the red (+) terminal, and then release the tab.

3.Connect the connecting plugs to the rear of the subwoofer by matching the colours of the speaker plugs to the speaker jacks.

Subwoofer

	RL
	ID SET
R	L
Front Speaker (R)	Front Speaker (L)

18 English

HT-D7100_ELS_1227.indd 18 2011-12-27 ￿￿ 1:18:40