2011-12-27 ￿￿ 1:18:42
English
19
ID SET
ID SET
ID SET button

!CAUTION

The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from water and moisture.

For optimal listening performance, make sure that the area around the wireless subwoofer location is clear of any obstructions.

Do not let children play with or near the speakers. They could get hurt if a speaker falls.

When connecting the speaker wires to the speakers, make sure that the polarity (+/–) is correct.

Keep the subwoofer speaker out of reach of children so as to prevent children from inserting their hands or alien substances into the duct (hole) of the subwoofer speaker.

Do not hang the subwoofer on the wall through the duct (hole).

NOTE

If you use a device such as a microwave oven, wireless LAN Card or any other device that uses the same frequency (5.2/5.8GHz) near the product, some sound interruption may be heard due to interference.

The transmission distance of radio wave is about 10M, but may vary depending on your operating environment. If a steel-concrete wall or metallic wall is between the main unit and the wireless subwoofer, the system may not operate at all, because the radio wave cannot penetrate metal.

If you place a speaker near your TV set, screen colour may be distorted because of the magnetic field generated by the speaker. If this occurs, place the speaker away from your TV set.

If the subwoofer is not connected from the power, you will see S/W CHECK on the display panel of the main unit.

Place the wireless subwoofer under the main unit.

If the main unit doesn't make wireless connection, the system needs ID Setting between the main unit and wireless subwoofer. With the main unit turned off, press the remote control's "0""1""3""5" number buttons and then turn on the unit. After connect to the

RL

power, press ID SET button on the rear of the subwoofer for 5 seconds.

02 Connections

Attaching the Toroidal Ferrite Core to the Speaker Cable

1.Open the bigger one of two toroidal ferrite cores by pulling the lock lever.

2.Arrange all the speaker cables that are connected to the subwoofer and make two loops.

Attach the ferrite core as close as possible to the subwoofer.

3.Place the toroidal ferrite core on the looped speaker cable as shown, and then press it closed it until you hear a click.

HT-D7100_ELS_1227.indd 19

Page 19
Image 19
Samsung HT-D7100/XE, HT-D7100/EN, HT-D7100/XN, HT-D7100/ZF manual Attaching the Toroidal Ferrite Core to the Speaker Cable