| Reverts all settings to their defaults |
| except for the network and Smart |
Reset | Hub settings, and then starts the |
Setup function. Requires that you | |
| enter your security PIN. The default |
| security PIN is 0000 |
Auto Sound Calibration
By setting the Auto Sound Calibration (ASC) function just once when you relocate or install the product, you can have the product automatically recognize the distance between speakers, levels between channels, and frequency characteristics to create a
AUX IN | FM ANT |
LAN |
|
| OUT |
|
|
|
L | OPTICAL | ASC IN | SPEAKERS | CENTER | FRONT | FRON |
|
|
|
|
|
| |
R | DIGITAL |
|
| SUBWOOFER | FRONT | FRON |
|
| IMPEDANCE : 3 | ||||
| AUDIO IN |
|
| |||
ASC microphone 
Auto Sound Calibration
Select whether to run and apply automatic sound calibration.
•Off: The unit produces sound according to the speaker configuration specified in Speaker Settings.
•On: The unit runs Auto Sound Calibration, and then produces sound optimized for your environment, according to the calibrated speaker settings.
Running Auto Sound Calibration
Before running the calibration, make sure there is no disc in the disc tray.
1.Plug the ASC microphone into the ASC IN jack.
2.Place the ASC microphone at the listening position.
•Auto Sound Calibration automatically runs and calibrates speakers in the following sequence : Front L Centre Front R Surround R Front Top R Front Top L Surround L Subwoofer
•Press the RETURN button to cancel the Auto Sound Calibration Setting.
Networks and the Internet
When you connect this product to a network, you can use network based applications and functions such as Smart Hub and
Configuring Your Network Connection
If you didn't configure your network connection during the initial settings procedure or you need to reset the network connection, follow the directions below.
Before you begin, contact your Internet Service Provider to find out if your IP address is static or dynamic. If it
is dynamic, and you have a wired or wireless network, we recommend using the Automatic configuration procedures described below.
If you are connecting to a wired network, connect the product to your router using a LAN cable before you start the configuration procedure.
To begin configuring your network connection, follow these steps:
1.In the Home screen, select Settings, and then press the E button.
2.Select Network, and then press the E button.
3.Select Network Settings, and then press the E button.
4.Go to the instructions for Wired networks starting below or the instructions for Wireless networks starting on page 26.
Wired Network
❑Wired – Automatic
After following Steps 1 to 3 above:
1.In the Network Settings screen, change Network type to Wired. Then, select Connect and press the E button. The product detects the wired connection, verifies the network connection and then connects to the network.
2.When it is done, highlight OK, and then press E button.
❑Wired - Manual
If you have a static IP address or the automatic procedure does not work, you'll need to set the Network Settings values manually.
04 Settings
