Network Setup

When you connect this product to a network, you can use network based applications and functions such as Smart Hub and BD-LIVE, and upgrade the product's software through the network connection. For more information about accessing and using Internet services, see the Network Services chapter of this manual on pages 43~50. Instructions for configuring the network connection start below.

Configuring Your Network Connection

If you didn't configure your network connection during the initial settings procedure or you need to reset the network connection, follow the directions below.

Before you begin, contact your Internet Service Provider to find out if your IP address is static or dynamic. If it is dynamic, and you have a wired or wireless network, we recommend using the Automatic configuration procedures described below.

If you are connecting to a wired network, connect the product to your router using a LAN cable before you start the configuration procedure.

To begin configuring your network connection, follow these steps:

1.In the Home screen, select Settings, and then press the OK button.

2.Select Network, and then press the OK button.

3.Select Network Settings, and then press the OK button.

4.Go to the instructions for Wired networks starting or the instructions for Wireless networks starting on the next page.

Wired Network

ĞĞWired – Automatic

After following Steps 1 to 3 above:

1.In the Network Settings screen, change Network type to Wired. Then, select Connect and press the OK button. The product detects the wired connection, verifies the network connection, and then connects to the network.

2.When it is done, highlight OK, and then press OK button.

ĞĞWired - Manual

If you have a static IP address or the automatic procedure does not work, you'll need to set the Network Settings values manually.

After following Steps 1 to 3 above:

1.In the Network Settings screen, change Network type to Wired. Then, select Connect and press the OK button.

The product searches for a network, and then displays the connection failed message.

If it is possible to connect the home cinema to your network wirelessly, select Change Network at this point, change the Network type to Wireless, and then go to the instructions for wireless networks on the next page.

Network Settings

Wired network connection failed.

MAC Address

XX:XX:XX:XX:XX:XX

IP Address

0.

0.

0.

0

Subnet Mask

0.

0.

0.

0

Gateway

0.

0.

0.

0

DNS Server

0.

0.

0.

0

Unable to connect to the network. Try the following: check if your IP address is set correctly in IP Settings. Contact your Internet service provider for more information.

Change Network

IP Settings

Retry

Close

2.Use the :;buttons to select IP Settings, and then press the OK button. The IP Settings screen appears.

3.Select the IP setting field, and then set it to Enter manually.

4.Select a parameter to enter (IP Address, for example), and then press OK. Use the 78 buttons on the remote control to enter the numbers for the parameter. Or use the Num keypad to enter a parameter number. Press and hold the 123 button until the Num pad appears on the screen. When the Num pad appears, select a number using the 78:;button and then press the OK button. Use the :; buttons on the remote control to move from entry field to entry field within a parameter. When done with one parameter, press the OK button.

5.Press the 7or 8button to move to another parameter, and then enter the numbers for that parameter following the instructions in Step 4.

Settings

23 - English