English-68
Setting Up the Remote to Operate Your Cable Box
Note on Using Remote Control Modes: Cable Box
When your remote control is in “Cable Box” mode, the volume buttons still control your TV’s volume.
1Turn off your cable box.
2Press the MODE button and make sure that the Cable LED is
illuminated.
3Press the SET button on your TV’s remote control.
4Using the number buttons on your remote control, enter three
digits of the cable box code listed on page 70 of this manual
for your brand of cable box. Make sure you enter three digits
of the code, even if the first digit is a “0.”
If there is more than one code listed, try the first one.
5Press the Power button on the remote control. Your cable box
should turn on if your remote is set up correctly.
If your cable box does not turn on after set up, repeat steps
2, 3, and 4, but try one of the other codes listed for your brand
of cable box. If no other codes are listed, try each code, 000
through 077.
victoryia 62-70 1/10/04 1:05 AM Page 68