Manuals / Samsung / TV and Video / CRT Television

Samsung PCJ532RF, PFJ533RF, PFJ534RF, PCJ611RF, PCJ614RF, PCK5315R, PCK6115R, PCK 6115R, PCJ 534RF

Models: PCJ532RF, PFJ533RF, PFJ534RF, PCJ611RF, PCJ614RF, PCK5315R, PCK6115R PCJ 614RF PCJ 534RF PCK 6115R

1 58

Download 58 pages 29.73 Kb

Page 27

O P E R AT I O N

Memorizing the Channels

Your TV can memorize and store all of the available channels for both “off-air” (antenna) and cable channels. After the available channels are memorized, use the CH ▲ and

CH ▼ buttons to scan through the channels. This eliminates the need to change channels by entering the channel digits. There are three steps for memorizing channels: selecting a broadcast source, memorizing the channels (automatic) and adding and deleting channels (manual).

Selecting the Video Signal-source

Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the TV (i.e., an antenna or a cable system).

1

Press MENU to display the menu.

2

Press CH ▼ two times to highlight “SET UP.”

3

Press VOL +.

The setup sub-menu will appear. Press CH ▼ to highlight ANT/CATV.

4

Repeatedly press VOL + to cycle through these choices:

ANT (antenna)

STD, HRC or IRC (all cable TV).

Note: STD, HRC and IRC identify various types of cable TV systems. Contact your local cable company to identify the type of cable system that exists in your particular area.

At this point the signal source has been selected. Proceed to “Storing

Channels in Memory” (next page).

CHAPTER THREE: TV OPERATION 3.5

Image 27

Samsung PCJ532RF, PFJ533RF, PFJ534RF, PCJ611RF, PCJ614RF, PCK5315R, PCK6115R, PCK 6115R, PCJ 534RF Memorizing the Channels

Contents

Owner’s Instructions Risk of Electric Shock Do not Open Thank You for Choosing Samsung Example Antenna Grounding FCC Information Installation Your New TVOperation Troubleshooting Special Features Chapter One List of Features Familiarizing Yourself with The TV Front Panel Jacks Super Video in jack Audio in jacks´ Video in jack Connect to an antenna or to a cable TV system Rear Panel JacksSuper Video Audio Inputs ˝ CH and CH Channel Up/Down PIPNumber buttons +100 For model PCJ533RF PIP Controls Remote Control ¸ VCR controls For model PCJ532RF/PCJ534RF PCK6115ROtherwise, the picture may Flicker Antennas with 300-ohm Flat Twin Leads Connecting VHF and UHF Antennas Cable without a Cable Box Connecting Cable TVAntennas with 75-ohm Round Leads Separate VHF and UHF Antennas Connecting to a Cable Box that Descrambles All Channels Connecting to a Cable Box that Descrambles Some ChannelsConnect this cable to a two-way splitter Unplug the cable or antenna from the back of the TV Connecting a VCR Antenna or cable to your VCR and your TV Connecting an S-VHS VCR Connecting a Second VCR to Record from the TV Connecting a Digital TV Set-Top Box Connecting a Camcorder Installing Batteries in the Remote Control Adjusting Basic Convergence Press PowerTurning the TV On and Off To do Left or Right Convergence Adjust Red Convergence Viewing the Display With the power on, press MenuViewing the Menus and On-Screen Displays Viewing the Menus Selecting a Menu Language Selecting the Video Signal-source Press CH two times to highlight SET UP Press VOL +Memorizing the Channels Storing Channels in Memory Automatic Method Press MENU, then press CH twice to highlight SET UP Adding and Erasing Channels Manual Method Using the Channel ButtonsDirectly Accessing Channels Changing Channels Setting the Clock Press the CH or CH button to select the correct minutesPress Menu three times to exit Adjusting the Volume Using MutePress VOL + or VOL to increase or decrease the volume Video icon will be highlighted starts blink- ing Customizing the Picture Alternate method Using Automatic Picture Settings Press Menu to display the menu Customizing the Sound Using Automatic Sound Settings Viewing a VCR or Camcorder Tape Video1 Video2 Video3Press TV/VIDEO to exit Customizing Your Remote Control Setting Up Your Remote Control to Operate Your VCRTurn off your VCR or Setting Up Your Remote Control to Operate Your Cable Box VCR Codes DVD CodesTurn off your cable box Codes Cable Box Press CH or CH to select the appropriate minutes Setting the On/Off Timer Setting the Sleep Timer When finished, pressPress the Sleep button on the remote control Viewing Closed Captions Press VOL+Press VOL+ to open Caption menu Select the appropriate channel Press Menu Fine Tuning Channels Press CH twice to highlight LNA LNA Low Noise Amplifier Dolby Prologic Special Audio Options Dolby Surround, MTS, and Headphones Drama, Action, or Theater Dolby 3D Phonic Press CH to highlight MTS Choosing a Multi-Channel Sound MTS Soundtrack Setting up Wireless Headphones with Picture-in-Picture Using Wireless Headphones Press VOL + to select PIP On Viewing Picture-in-PictureActivating Picture-in-Picture Press VOL + to select PIP menu Selecting a Signal Source Antenna or Cable for PIP Selecting a Signal Source External A/V for PIPSwapping the Contents of the PIP image and Main image Changing the Size of the PIP Window Changing the PIP ChannelChanging the Location Rotating the PIP Window Freezing the PIP Image Using the V-Chip Setting Up Your Personal ID Number PINPress CH six times to select the V-chip menu Press VOL+ How to Set up Restrictions Using the TV guidelines How to Enable/Disable the V-Chip TV-14 TV-Y Young children TV-Y7 Children 7 and overGeneral audience Parental guidance E C I a L F E AT U R E S NC-17 Chapter Five Identifying Problems Cleaning and Maintaining Your TV Using Your TV in Another CountrySpecifications