Samsung PL-50D4H manual Memorizing the Channels, Selecting the Video Signal-source

Memorizing the Channels

Your PDP can memorize and store all of the available channels for both “off-air” (antenna) and cable channels. After the available channels are memorized, use the

CH and CH buttons to scan through the channels. This eliminates the need to change channels by entering the channel digits. There are three steps for memorizing channels: selecting a broadcast source, memorizing the channels (automatic) and adding and deleting channels (manual).

Selecting the Video Signal-source

Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the PDP (i.e., an antenna or a cable system).

Press the MENU button. Press the ▲ or ▼ button to

1 select “Channel”, then press the ENTER button.

2 Press the ENTER button to select “Air/CATV”.

Press the ▲ or ▼ button to select “Air”, “STD”,

3 “HRC” or “IRC”, then press the ENTER button.

•If you are connected to an antenna, leave “Air” displayed. If you connected cable, press the

▲ or ▼ button to the display the type of cable system: “STD”, “HRC” or “IRC”.

(If you are not sure which type of cable system you have, contact your cable company).

4 Press the MENU button to exit.

TV		Channel
	Air/CATV	: Air		√
	Auto Program			√
	Add/Delete			√
	Fine Tune			√
	LNA	: On		√
	Scan			√
	Move	Enter	Return
TV		Channel
	Air/CATV	: Air	Air
	Auto Program
			STD
	Add/Delete
			HRC
	Fine Tune
			IRC
	LNA	: On
	Scan
	Move	Enter	Return
TV		Channel
	Air/CATV	: Air	Air
	Auto Program
			STD
	Add/Delete
			HRC
	Fine Tune
			IRC
	LNA	: On
	Scan
	Move	Enter	Return

Note

•STD, HRC and IRC identify various types of cable TV systems. Contact your local cable company to identify the type of cable system that exists in your particular area. At this point the signal source has been selected. Proceed to “Storing Channels in Memory” (Next page).

31