Freezing the Current Picture

You can freeze the picture when watching a television programme simply by pressing the “STILL” button. To return to normal viewing, press it again.

➢This function will automatically cancel five minutes later.

When the television is initially powered on, several basic customer settings proceed automatically and subsequently.

The following settings are available.

1If the television is in standby mode, press the POWER () button on the remote control. The message to start Plug & Play is displayed.

Plug & Play

Start Plug & Play

Enter Exit

2The Language menu will automatically appear after several seconds.

3Select the appropriate language by pressing the … or † button.

Press the ENTER/OK ( ) button. The message to check the connected status of the antenna is displayed.

4Make sure that the antenna is connected to the TV.

Press the ENTER/OK ( ) button. The Country menu is displayed.

5Select your country or area by pressing the … or † button.

Press the ENTER/OK ( ) button. The menu to select channels is displayed.

6To start channel store, press the ENTER/OK ( ) button.

The search will end automatically. The TV will begin memorizing all of the available channels. Press the ENTER/OK ( ) button to set the clock.

7Press the œ or √ button to select the hour or minute. Set these by pressing the … or † button.

➢ You can enter the Hour, Minute by using the numeric buttons on the remote control.

8Press the ENTER/OK ( ) button to confirm your setting.

The DTV channel scan menu appears and the DTV channel is automatically updated.

➢

If the DTV channel is updated, the Source in the source list of the Input menu is automatically changed to DTV.

For detailed descriptions about DTV channel update, refer to page 23 of this manual.

2Press the … or † button to select Setup, then press the ENTER/OK ( button.

3Press the ENTER/OK ( ) button again to select Plug & Play. The message to start Plug & Play is displayed.

English - 9