1.Pull out the freezer drawer (1 ) to reveal the lower hinge ( 2 ).
2.Insert the supplied allen wrench (3/16”) ( 3 ) into the shaft ( 4 ) of the lower hinge.
3.Adjust the height by turning the
hex wrench ( 3 ) clockwise ( DOWN ) or counter clockwise ( UP ).
When you turn the hex wrench counter-
clockwise(), the door will move up.
2 |
|
3 | 3 |
4 |
|
1
After you have connected the water line, make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water outlet.
Water line installation kits are available at extra cost from your dealer.
We recommend using a water line installation kit that contains copper tubing and ¼” compression nut.
Connecting to the water supply line
1.
supply.
01 SETTING UP
4. After adjusting the doors, insert the supplied | 2. Locate the nearest cold water drinking line and | |
fastener ( 6 ) using a pliers ( 5 ) in the gap | ||
| ||
between the |
| |
hinge ( 8 ). The number of fasteners you’ll need |
| |
to insert depends on the gap. | Cold water line | |
| Pipe clamp | |
| Shut off valve |
2 fastener are enclosed with the refrigerator. The thickness of each fastener is 0.04”.
INSTALLING THE WATER DISPENSER LINE
A water dispenser with a filter is one of the helpful features on your new refrigerator. To help promote better health, the water filter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water pressure of 20~125psi ( 138~862kPa) is required.
If the refrigerator is installed in an area with low water pressure (below 20psi), you can install
a booster pump to compensate for the low pressure.
3.Connect the water line installation kit to the
Cold water line
Water line installation kit
Pipe clamp
Shut off valve
Connecting the water supply line to the refrigerator.
There are several items that you need to purchase to complete this connection.
You may find these items sold as a kit at your local hardware store.
Use Copper Tubing | Use Plastic Tubing | ||
t | ¼” copper tubing | t | ¼” plastic tubing |
t ¼” compression nut (1pc) |
| Molded end(Bulb) | |
t | Ferrule (2pc) | t | ¼” compression nut (1pc) |
|
|
|
|
13_ setting up
2012.3.31 9:49:43 AM