Samsung RF263BEAEBC, RF263BEAEWW Using The Cold Water Dispenser, Maintaining the Ice Bucket

Fridge button to set your desired temperature. After a few seconds, the Fridge will begin adjusting towards the newly set temperature. This will be reflected in the digital display.

Recommend Temp (Fridge) : 37°F (or 3°C )

The- temperature of the Freezer, Fridge or Cool Select Pantry Zone may rise when you open the doors too frequently, or if a large amount of warm or hot food is placed inside.

-This may cause the digital display to blink. Once the Freezer and Fridge temperature return to their normal set temperatures, the blinking will stop.

-If the blinking continues, you may need to “reset” the Refrigerator. Try unplugging the appliance, wait for around 10 minutes and then plug the power cord back in.

-If there is a communication error between the Display and Main Controller, the Convertible Display light may blink. If the blinking continues for a long period of time, please contact a Samsung Electronics Service Center.

USING THE COLD WATER DISPENSER

Push the appropriate ice type button to select what you want dispensed.

NO ICE

Select this if you want to

Using the ice Dispenser Place a glass underneath the ice dispenser and push gently against the dispenser lever with your glass.

Make sure the glass is in line with the dispenser to prevent the ice from bouncing out.

Please wait 2 seconds before removing the	02
CAUTION glass under the dispenser to prevent spills.
	OPERATING
CAUTION the Crushed Ice mode, a small amount of
If the Refrigerator door opens, the
Dispenser does not work.
When Cubed Ice is selected after using
residual crushed ice might be produced.
Do not pull the lever out. You could damage
CAUTION
or break the lever’s spring.

check the water level

Test button

Maintaining the Ice Bucket

tTo clean the ice bin/bucket, wash with a mild detergent, rinse well, and dry thoroughly it. Do not use harsh or abrasive cleaners or solvents.

tThe ice cubes generated by the rapid ice making process will look white, which indicates they are generated normally.

tAs the ice maker in the refrigerator room makes ice cubes even faster, move the ice cubes from the refrigerator ice bin to the freezer ice bin if you need more ice cubes.

tIf ice doesn’t come out, pull out the ice bucket and press the test button located on the right side of ice maker.

tDo not press the test button continuously when the tray is filled with ice or water. Water may overflow or ice may jam the bucket.

tNormal Use

To fill the ice bucket to maximum capacity after installation, follow these steps:

Water may overflow or ice may jam the bucket.

operating _19

DA68-02601A(EN+FR+ES)-0.2.indb 15

2012.3.31 9:49:48 AM