CheckChhe | the |
watewat r level | |
Botón Test (Probar) | |
To remove the ice cubes without use the
WARNNIG
(Remove the front cover of the Ice Maker)
Ice cubes in the ice machine may leak on the drawer.
Not put food into the tray of ice.de hielo.
WARNNIG If you store food in the ice bucket,may hinder the ice maker to open or close the door, and damage the ice maker.
Note that the ice cubes from the ice bucket WARNNIG can spill over the box to remove the tray from
the drawer. In this case, you must remove the drawer the ice cubes that have been spilled.
In case of power outage, ice cubes can melt WARNNIG and then freeze when power returns, causing
the dispenser to stop working.
To prevent this from happening after a power outage, remove the ice bucket and discard the ice and wastewater.
If you use all the ice at one time, repeat Steps 2 and 3 on the previous page.
However, wait only 8 hours before removing the
cubes and ensure their maximum output.
may have bad taste.
How to Use Ice Off function
remove all ice cube tray. If not using the ice dispenser, it is possible to stack the cubes. Hold down the button. Remove the tank in the direction of the arrow. Dispose of ice cubes or ice mass. Push the bottom of the tray until it clicks.
and try again.
Use only the ice maker refrigerator. Only a suitably
WARNNIG
supply to the refrigerator. Connect only to a potable water supply.
In order that the ice maker work properly, need a water pressure of 20 ~ 125 psi (138 ~ 862 kPa). Whether traveling for vacation or business and will not use water dispensers and ice for an extended period:
-Remove all food.
-Unplug the refrigerator.
-Remove excess moisture from inside the refrigerator and leave doors open. Otherwise,
hands or any other inappropriate object in the container or bucket of ice maker.
It may cause personal injury or property damage.
Never try to take the ice maker.
-Do not wipe or spray the ice tray with water while in the refrigerator. Remove for cleaning.
When inserting the tray of the ice maker, WARNNIG make sure it is well centrada.De Otherwise,
you could lock.
The phenomenon of turbidity
The water entering the cooler circulates through
oxygen and nitrogen. When it is contacted with air, the pressure drops rapidly and the oxygen and nitrogen is oversaturated and generate gas bubbles. Temporarily, water can have a cloudy appearance due to these bubbles of oxygen. After a few seconds, water is colorless.
20_ operating
2012.3.31 9:50:26 AM
