Samsung RF263BEAESR, RF263BEAEWW, RF263BEAEBC Completing the SET UP, Seconds, Setting up14

Refrigerator

Only connect the water line to a drinkable water source.

If you have to repair or disassemble the water line,

get a snug, leak-free connection.

You can test the water line quickly using a

paper cup.Under normal conditions, the water

Compression Nut (1/4”)

(Assembled)

Ferrule (Not supplied)

Plastic Tubing (Assembled)

Compression Fitting (Assembled)

Molded end(Bulb)

Compression nut (B) (1/4”) (Not supplied)

10 seconds.

COMPLETING THE SET UP

Now that you have your new refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance.

By completing the following steps, your refrigerator should be fully operational.

Copper tubing or	Plastic tubing (B)
(Not supplied)	(Not supplied)

Household water supply line

1.Connect the household water line to the assembled compression fitting.

-If you are using copper tubing, slip the compression nut ( B ) (not supplied) and ferrule (not supplied) on the copper tubing (not supplied) as shown.

-If you are using plastic tubing ( B ) , insert the molded end (Bulb) of the plastic tubing ( B ) into the compression fitting.

Do not use without the molded end (Bulb) CAUTION of the plastic tubing ( B ).

2.Tighten the compression nut ( B ) onto the compression fitting.

Do not over-tighten the compression nut ( B ) .

3.Turn water on and check for any leakage. If you find water drops or leakage in the connection

the connections and, if necessary, tighten.

4.Flush 1 gallon of water through the filter before drinking or using the water from the refrigerator. (Flush approximately 6 minutes.) To flush, press a large glass or cup against the water dispenser lever. Fill the glass, empty it into the kitchen sink after it is filled, and then repeat.

5.After you turn on the refrigerator, let the ice maker make ice for 1 to 2 days. Over that period of time, throw out the first 1 or 2 buckets of ice the freezer makes to ensure all impurities have been removed from the water line.

setting up_14

1.Make sure your refrigerator is in an appropriate location with reasonable clearance between it and the wall. Refer to installation instructions in this manual.

2.Once the refrigerator is plugged in, make sure the interior light comes on when you open the doors.

3.Set the Temperature control to the coldest temperature and wait for an hour. The freezer will get slightly chilled and the motor will run smoothly. Reset the refrigerator and freezer to the temperatures you want.

4.After you plug the refrigerator in, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the refrigerator after the temperature is sufficiently cool.

In the event of a power failure, call the local offi ce of your Electricity Company and ask how long it is

going to last.

-Most power failures that are corrected in an hour or two will not affect your refrigerator temperatures. However, you should minimize the number of door openings while the power is off.

-But Should the power failure last more than 24hours, remove all frozen food.

If the key is provided with refrigerator, the keys should be kept out of the reach of children and not be in the vicinity of the appliance.

The appliance might not operate consistently (possibility of defrosting of co tents or temperature becoming too warm in the frozen food compartment) when sited for an extended period of time below the cold end of the range of temperatures for which the refrigerating appliance is designed.

DA68-02601A(EN+FR+ES)-0.2.indb 11

2012.3.31 9:49:44 AM