Samsung RF26XAEPN, RF267AEBP, RF267AE** Troubleshooting, unit normal?, NO0.6V Measurement

TROUBLESHOOTING

5) If F Sensor has trouble

ERROR Code

2¢ (-17¡ ) is recommended 38¢ (3¡ ) is recommended

DATA1.

Temperature table

**Measuring point of resistance value according to Sensor **

F : CN30#3 CN76#1 measuring resistance value

** 0 : Short trouble / : Open trouble

Refer to circuit diagram in the manual

Sensor MICOM/Connector number

FConnector Cn30#3(Red) to

REG1 HEAT-SINK PCB common Ground

Voltage measured between 4.6V ~ 0.6V.

Measuring voltage of IC01 MICOM #81,

CN30-"3"(Yellow) and REG1, HEAT SINK from PCB typical Ground part are similar.

Check the measure on the SENSOR MARKING

#1(R309) due to the SMD MICOM

Start

Are MAIN PCB		NO
Connector CN30 to CN76 inserted
correctly?
	YES
		NO	Bad contact of connector/ insert correctly
Is F Sensor
unit normal?
	YES		Replace temperature sensor
Is the voltage between		NO(0.6V > Measurement < 4.6V)
MAIN PCB Connector CN30#3 (Red) and REG1,
HEAT SINK normal?
	YES		Check the contact of PCB & Wire
Is the input voltage of		NO	Terminal correctly.
IC01 MICOM #81 normal?
	YES		Check the iced-solder, solder bridging,
			disturbed solder. Replace the PCB
No trouble with PCB and temperature sensor
Recheck the bad contact of the connection

Checking method of F Sensor resistance CN30#3(Red) CN76#1(Gray)

- Compare the temperature table after the measure

Checking method of F Sensor voltage

- Measure the voltage of Sensor Check Point #1

(IC01 MICOM #81) or CN30#3(Red) REG1, HEAT SINK. - Compare the temperature table after the measure. Measuring

voltage of CN30#3(Red) REG1, HEAT SINK are below.

typical PCB Ground

REG1 HEAT-SINK

62