Samsung SCC-C6403P manual Color/Bw, Motion Det, Auto

COLOR/BW

In the COLOR/BW menu, you can switch ON or OFF the IR (infrared) Filter.

❈In AUTO mode, AGC will be displayed as “---“. You can’t adjust the settings manually.

In a poor illumination environment, the IR filter is turned off in the BW mode the its sensitivity increases as high as a black and white camera. On the other hand, the IR filter is turned on and the sensitivity decreases in the COLOR mode.

COLOR : The IR Filter is ON and the screen is normal. You can press the [Enter] key to set the COLOR GAIN LEVEL. And when the AGC function is on, you can set the AGC COLOER LEVEL.

(CAMERA SET)
CAMERA ID	OFF
V-SYNC	INT
COLOR/BW	AUTO...
MOTION DET	OFF
ZOOM SPEED	3
DIGITAL ZOOM	OFF
DISPLAY ZOOM	OFF
DISPLAY P/T	OFF

➜

Press [Enter]

(AUTO)

BURST	ON
LEVEL	LOW
DURATION	S ------ L

(CAMERA SET)
CAMERA ID	OFF
V-SYNC	INT
COLOR/BW	COLOR …
MOTION	OFF

➜

(COLOR)

EXIT QUIT

RET

E

ZOOM SPEED	3
DIGITAL ZOOM	OFF
DISPLAY ZOOM	OFF
DISPLAY P/T	OFF
EXIT	QUIT

Press [Enter]

GAIN	(0)I--------
AGC COLOR	(0)----I----
RET

Caution : If you use an infrared light source while in AUTO mode, AUTO switching malfunction and camera AF malfunction may occur.

MOTION DET

BW	: The IR Filter is OFF and the screen is black and white.
	(Sensitivity to low light is increased to a level comparable to a black
	and white camera.)
	Select BW and press [ENTER] and the additional menu to select
AUTO	BURST ON/OFF will appear.
	: Select to automatically switch between the COLOR mode and BW

In MOTION DET, you can set the Motion Detection function, Motion Detection Sensitivity, and the Area of Motion Detection. If the Motion Detection function is set, the movement of an intruder can be detected. When motion is detected, it sets off the Alarm signal of the Controller.

mode depending on the amount of light. In low light conditions, the

IR Filter is turned OFF and the sensitivity to low light is increased

by switching to the BW mode, but in bright light conditions, the IR

Filter is turned ON and the sensitivity is decreased by switching to

the COLOR mode.

Select AUTO and press [ENTER] and the additional menu to select

BW LEVEL and DURATION will appear.

-BURST ON : The color burst signal is output together with black and white composite video signal.

-BURST OFF : The color burst signal is not output.

-LEVEL : You can set the brightness level that changes from COLOR mode to BW mode in 3 steps : LOW, MEDIUM, and HIGH.

-DURATION : Set the HOLDING time for switching between COLOR and BW mode depending the changes in the amount of light. You can set the HOLDING time to 10sec (S), 30sec, 60sec, or 300sec( L).

(CAMERA SET)
CAMERA ID	OFF
V-SYNC	INT
COLOR/BW	COLOR...
MOTION DET	ON...
ZOOM SPEED	3
DIGITAL ZOOM	OFF
DISPLAY ZOOM	OFF
DISPLAY P/T	OFF
EXIT	QUIT

➜

Press [Enter]

(MOTION DET)

AREAUSER...

SENSITIVITY L ------ H RET

3-6 3-7