Samsung SCX-4x26 manual Solving Other Problems, Paper feeding, Condition Suggested Solutions

MESSAGE	MEANING	SUGGESTED
		SOLUTIONS
Toner Exhausted	The lifespan of the	This message appears
T	toner cartridge which	when the toner is
	the arrow indicates is	completely empty, and
	reached.	your machine stops
		printing. Replace the
		corresponding toner
		cartridge with a Samsung-
		genuine cartridge. See
		page 60.
Toner Low	The corresponding	Take out the toner
T	toner cartridge is	cartridge and thoroughly
	almost empty.	shake it. By doing this, you
		can temporarily
		reestablish printing
		operations.
Updating Data	This message	Do not turn the power off
Please Wait...	appears when there is	when this message is
	a change in the	showing. Changes may
	system setting or	not be saved and datas
	when you back up a	can be lost.
	data.

SOLVING OTHER PROBLEMS

The following chart lists some conditions that may occur and the recommended solutions. Follow the suggested solutions until the problem is corrected. If the problem persists, call for service.

Paper feeding

CONDITION	SUGGESTED SOLUTIONS
Paper is jammed	Clear the paper jam. See page 63.
during printing.
Paper sticks	• Ensure there is not too much paper in the tray.
together.	The tray can hold up to 250 sheets of paper,
	depending on the thickness of your paper.
	• Make sure that you are using the correct type
	of paper. See page 35.
	• Remove paper from the tray and flex or fan the
	paper.
	• Humid conditions may cause some paper to
	stick together.
Multiple sheets of	• Different types of paper may be stacked in the
paper do not feed.	tray. Load paper of only one type, size, and
	weight.
	• If multiple sheets have caused a paper jam,
	clear the paper jam. See page 63.
Paper does not feed	• Remove any obstructions from inside the
into the machine.	machine.
	• Paper has not been loaded correctly. Remove
	paper from the tray and reload it correctly.
	• There is too much paper in the tray. Remove
	excess paper from the tray.
	• The paper is too thick. Use only paper that
	meets the specifications required by the
	machine. See page 30.
	• If an original does not feed into the machine,
	the ADF rubber pad may require to be
	replaced. See page 61.
The paper keeps	• There is too much paper in the tray. Remove
jamming.	excess paper from the tray. If you are printing
	on special materials, use the manual tray.
	• An incorrect type of paper is being used. Use
	only paper that meets the specifications
	required by the machine. See page 30.
	• There may be debris inside the machine. Open
	the front cover and remove the debris.
	• If an original does not feed into the machine,
	the ADF rubber pad may require to be
	replaced. See page 61.
Envelopes skew or	Ensure the paper guides are against both sides of
fail to feed correctly.	the envelopes.

Troubleshooting_ 69