monitor
You can select which item(s) to be displayed on the screen.
Setting the monitor
Using the mouse may help make setup easier.
1. | Use the up/down buttons ($%) in <Device> window to |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
| Monitor |
|
|
|
|
|
|
| |||
| move to <monitor>, and press [enTeR] button. |
|
| Monitor |
| Mode |
|
|
|
|
| |
2. | Select <monitor>. |
|
|
|
|
|
|
|
|
|
| |
|
| Event Display |
| OFF |
|
|
|
|
| |||
|
| Display |
| Date |
| Time | CH Name Icon |
|
| |||
3. | Use direction buttons ($%_ +) to move to a desired |
|
| Video Output |
|
|
|
|
|
|
| |
|
|
| VGA |
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
| |||
| item, and set the value. |
|
|
|
|
|
|
|
|
|
| |
• Event Display : Sets the dwell time of the event channel |
|
|
|
|
|
|
|
|
|
| ||
| display on the monitor when an event occurs. |
|
| Display Position Setup |
|
|
|
|
| |||
| If selected <Continuous>, it displays the channel until you |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
| OK |
| Cancel |
|
|
| ||
| press [aLaRm] button to release it. |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
•Display : Displays only checked items on the monitor screen.
•Video Out: You can set the video output mode.
-Auto : The default is set to Composite. (In VGA mode, the “SAMSUNG” logo will be displayed)
If a VGA source is connected, the source from the VGA will be displayed as main. (In Composite mode, the spot screen will be displayed)
The monitor distributor is not supported.
To switch to VGA mode, turn off the DVR set and connect the VGA jack. (The VGA monitor will turn on)
-VGA : The main video mode will switch to VGA after the DVR set reboots; the composite source will be displayed on the spot screen.
-Composite : The main video mode will switch to Composite after the DVR set reboots. In VGA mode, the “SAMSUNG” logo will be displayed.
4.When the monitor setup is done, press <OK>.
Setting Display position
Some monitors many not display information (camera name, icon, time information, etc.) about the DVR, depending on the condition. Then, you can change the display position of the data.
1.In the <Device> window, press the up/down ($%) button
to move to <monitor> and press the [enTeR] button. 2012-01-01 01:10:25
2.Select the <monitor> item.
3. | Select <Display Position Setup> in the bottom. | Display Position Setup |
|
30 | 30 | ||
30 | |||
4. | You will move to the <Display Position Setup> window. |
| 30 |
Use the four direction buttons or the number buttons on | OK | Cancel | |
CAM 03 |
| ||
| the remote control to adjust the data position. |
|
|
!main menu