using the PTZ camera
You can use one camera to perform all functions of PAN, TILT and ZOOM for monitoring multiple places and set the preset to your preference in a desired mode.
1. Launch the <PTZ Control> menu. |
| |||
As the PTZ < | > icon on the bottom right corner turns |
| ||
yellow, you access the “PTZ Control” mode to display the |
|
|
| |
“PTZ Control” menu. |
|
|
| |
M ` Be sure to configure PTZ working environments before |
|
|
| |
operation, since the PTZ Working(Active) mark can be | PTZ Control CAM01 | Select | Select Preset | |
appeared to be activated even when PTZ is not operative. | Scan | |||
|
| Auto Pan | Select | Camera Setup |
2. Use the PTZ wheel in the launcher menu to adjust the | Pattern | Select | Save Rename | |
Exit |
| DeleteDeleteDeleteDeleteAll All | ||
monitoring area, or use the direction buttons ($%_ +) on | Preset | Select | ||
|
|
| ||
the remote control to move the camera to a desired place. |
|
|
|
•PTZ Wheel : Clicking a nearer point to the center will move in that direction slowly; clicking a farther point from the center will move fast.
`Keep clicking left to rotate the lens counter clockwise; keep clicking right to rotate the lens clockwise.
•Zoom ( ) : You can use the Zoom function of the PTZ camera.
•IRIS ( ) : Adjusts the intensity of radiation incoming to the iris.
•Focus ( ) : Enables you to adjust the focus manually.
•Auto Pan : The camera automatically runs between the two points that you selected.
•Scan : The camera moves to the preset points in the specified sequence.
If multiple presets are specified, the PTZ camera will automatically move to all of the preset points one at a time.
•Pattern : Makes the PTZ camera remember and follow the past route.
`The functions of Auto Pan, Scan and Pattern are supported in the protocols of Samsung, Panasonic and Pelco, and are different in terms of the name and setting, depending on the protocols of Samsung, Panasonic and Pelco.
(Panasonic : Auto Pan, Sequence, Sort / Pelco : Auto Pan, Frame Scan (Scan), Pattern)
M ` Before entering the PTZ device control mode, set the values of the PTZ device in the <Setting the PTZ> menu. (Page 46)
!SeaRCH & PLaY