Samsung SHR-8160, SHR-7082, SHR-7080 Hdd alarm, Appears on the Live screen, Manage, HDD Alarm

using the DVR

.Select <Format> on the bottom of the screen.

Press <oK> on the “manage” confi rmation window will start formatting the selected device.

.When the formatting is done, press <oK>.

hdd alarm

Storage Device

Device		Format		HDD Alarm
Device		Select	Used/Total		Usage
HDD	1		12.28G/499.37G		Internal

Manage

Formatting deletes all recordings.

Proceed formatting?

OK Cancel

Format

OK Cancel

You can set alarm settings for HDD defects such as Check Alarm Output Port, Replace Alarm Output Port, and its duration.

Using the mouse may help easy setup.

.Use the up/down buttons (▲▼) in <device> window to move to <storage device>, and press [enter] button.

.Select <hdd alarm>.

A window for setting HDD check and replace output ports and their durations appears.

.Use direction buttons (▲▼_ +) to move to the desired item.

~Alarm

-Alarm signal will output through the alarm out port on the rear side when selected <1>, <2>, <3>, and <4>.

Storage Device
Device	Format		HDD Alarm
 Check Alarm Output Port		1	2	3
		4	BEEP	All
 Duration		OFF
 Replace Alarm Output Port		1	2	3
		4	BEEP	All
 Duration		OFF
		OK	Cancel

-If <Beep> was selected, a beep will sound.

-If <all> was selected, both beep sound and alarm signal through rear side ports will output.

~Check Alarm Output Port : If HDD generates check alarm, the alarm signal will output to the specifi ed alarm output port.

~Replace Alarm Output Port : If HDD generates replace alarm, the alarm signal will output to the specifi ed alarm output port.

~Duration: Sets the alarm duration for the alarm signal and beep sound.

-Check Alarm, Replace Alarm signals will output through the selected alarm out ports (1, 2, 3, and 4).

-If <Beep> was selected, a beep will sound.

-If <all> was selected, both beep sound and alarm signal through rear side ports will output.

M	` <Check> status means that the HDD is operating but it has problems that require technical examination.
	(	) appears on the Live screen.

`<Replace> status means that the HDD has defect and requires immediate replacement.

( ) appears on the Live screen.

.When the HDD Alarm setup is done, press <oK>.

_ using the DVR

00769B_SHR-8162_ENG-NEW.indb 44

2008-12-04 오전 10:15:26