network connection and setup
IPv4 | Scans for cameras with the IPv4 setting. | |
|
| |
IPv6 | Scans for cameras with the IPv6 setting. | |
|
| |
Search | Scans for cameras that are currently connected to the network. | |
However, this button will be grayed out if neither IPv4 nor IPv6 is checked. | ||
| ||
|
| |
Auto Set | <IP Installer> will automatically configure the network settings for you. | |
|
| |
Manual Set | You should configure the network settings manually. | |
|
| |
Exit | Exits the IP Installer program. | |
|
|
STATIC IP SETUP
Manual Network Setup
Run <IP Installer.exe> to display the camera search list.
At the initial startup, both [Auto Set] and [Manual Set] will be grayed out.
M For cameras found with the IPv6 setting, these buttons will be grayed out as the cameras do not support this function.
1.Select a camera in the search list.
Find the MAC (Ethernet) address labeled on the rear of the camera.
Both the [Auto Set] and [Manual Set] buttons will be activated.
2.Click [Manual Set].
The MANUAL SET dialog appears. The default values of <IP Address>,
<Subnet Mask>, <Gateway>, and <HTTP Port> of the camera will be displayed. The default <PASSWORD> is 4321.
3.In the <ADDRESS> pane, provide the necessary information.
MAC (Ethernet) Address : The MAC (Ethernet) address of the applicable camera will be set automatically so you don't need to input it manually.