setup screen

-Post-alarm duration : The post alarm duration can be one among 5 seconds, 10 seconds, 15 seconds, and 30 seconds. You can send a post-alarm image of up to 30 seconds after the alarm is triggered.

(The max time differs, depending on the frame rate)

MThe pre/post alarm duration is not available in SMTP transfer mode. Only one image at the corresponding time will be transferred.

2.When done, click [Apply]. Your settings will be saved.

To set the alarm input

1.Select <Event> - <Alarm input 1> or <Alarm input 2>.

The Alarm Input setup window appears.

2.When done, click [Apply]. Your settings will be saved.

￿Input device setup : Select an input type according to the characteristics of the alarm sensor on the rear of the camera.

-Off : Turns off the alarm input setting.

-NO (Normal Open) : It is normally open, but if it is closed, an alarm will be triggered.

-NC (Normal Close) : It is normally closed, but if it is open, an alarm will be triggered.

￿Activation time : You can set a time to execute a specifi c command when an alarm occurs.

-Always : Always executes the specifi ed command when an alarm occurs.

-Only scheduled time : Activates notifi cation as confi gured only when alarm events occurred during the specifi ed time period.

￿Action : You can set an action to execute when an alarm occurs.

-Alarm output : Set the alarm output port to which the alarm signal is transferred.

-Output duration : Set the period of time to output the alarm signal to the specifi ed alarm output port when an alarm occurs.

If a new alarm event is detected during the alarm output, the delay time is recalculated based on the detection time of the recent alarm.

-Alarm image transfer : If you select <On>, you can transfer JPEG images to a registered address via FTP or SMTP server or save images into the SD memory card according to the setting in <Event> - <Transfer setup>.

62_ setup screen