New setting appears on [Basic] menu. Type t and press [ENTER : ↵ ] if you would like to return to the top menu [ROOT]. Otherwise, you will remain in [Basic] menu.
③Select the following order to change Wireless Channel.
CMD(t,p,h): 2 ↵ | Select Slot |
| |
Select slot {A, B}: a ↵ | Enter Channel |
| |
Enter new Channel | |
|
|
Select slot (A or B) which is you want to set Channel after the phrase “Select slot {A, B}:”, and press [ENTER : ↵ ]. We recommend you use different Channel for each slots refer Notice blow.
Enter the proper channel number after the phrase “Enter new Channel {1- 14}:”. Then, press [ENTER : ↵ ]. Channel index should be between 1 and 14(differs from country to country).
Notice : If you are operating two or more Access Points in the adjoining cells, keep the appropriate channel distance to avoid the interference. We recommend you to keep the distance of at least 4 channels in the adjoining cells.
④Only if AP is used for DHCP Client, you set DHCP Client with “Enabled”. In this case, there is no need to set ⑤, ⑥, ⑦ below. The default setting is “Disabled”.
CMD(t,p,h): 3 ↵ | Enter DHCP | Client |
Setting Selection |
| |
|
| |
Enter new DHCP Client {enable, disable}: disable ↵ |
|
|
|
|
|
66
