3-4 Set up the Model option
The Method for Setting up the model option with remocon
• It is necessary to set up option code after replacing the
Make sure that you can set up the option of code the remote controller after you replace the main PBA otherwise, the unit won’t be working properly and all LED lamps on display will be flickering.
Step 1 : Preparing the remocon to main PCB option set |
| |
1st | Remove the battery from the remocon. |
|
2nd | Press the temperature raise/down button simultaneously | |
| and insert the battery again. |
|
3rd | Make sure the remocon display shown as | . |
Step 2 : Second stage preparation of the remocon option set.
❈Note ; In case the wrong letter has been selected, continue to press the button until the correct letter appears.
1st | If the first stage number “ ” appears on the display, proceed to the second stage. |
2nd | Every time the ! and & button, “ ” and “ ” each continue to appear. |
3rd | Whenever pressing the @, #, $, %, ^, *, (, ), 1, 2 button, the number increase from |
| 0~9(0123456789) and A, b, C, d, E, F each time. |
!If the first number is , it is correct otherwise press until
appear.
@When pressing the button ~ appear on the display,
select one of them.
#When pressing the button ~ appear on the display,
select one of them.
$ When pressing the button ~ appear on the display, select one of them.
% When pressing the button ~ appear on the display, select one of them.
^When pressing the button ~ appear on the display, select one of them.
20