No | Parts |
| Procedure | Remark | |
|
|
|
|
| |
2 | Electrical Parts | 1) Do “1”above. |
|
| |
|
| ||||
| (Main PCB) | 2) | Take all the connector of PCB upper side out. |
|
|
|
|
|
| ||
|
|
| (Inclusion Power cord) |
|
|
|
| 3) | Separate the outdoor unit connection wire from |
|
|
|
|
| the terminal block. |
|
|
|
| 4) | If pulling the Main PCB up. it will be taken out. |
|
|
|
|
|
|
| |
|
|
|
|
|
|
3 | Ass’y Tray Drain. | 1) Do “1”, “2”, above. |
|
| |
|
| ||||
|
|
| Separate the drain hose from the extension |
|
|
|
|
| drain hose. |
|
|
|
| 2) | Pull tray drain out from the back body. |
|
|
|
|
|
|
|
|
4 | Heat Exchanger | 1) Do “1” and “2”, “3”, above. |
2)Loosen two fixing earth screws of right side.
3)Separate the connection pipe.
4)Separate the holder pipe at the rearside.
5)Loosen the three fixing screws of right and left side.
6)Lifting the heat exchanger up a little to push the up side for separation from the indoor unit.
5 | Fan Motor and | 1) Do “1”, “2”, ”3”, “4”, above. | |
| Cross Fan |
|
|
|
| 2) | Loosen the fixing two screws and separate the |
|
|
| motor holder. |
|
| 3) | Loosen the fixing screw of fan motor. |
|
|
| (By use of M3 wrench) |
|
| 4) | Separate the fan motor from the fan. |
|
| 5) | Separate the fan from the left holder bearing. |
4